![]() ![]() The subnet mask determines what portion of the TCP/IP address represents your network and what portion can be used for your hosts. You have a network and you have hosts on the network (anything with an IP address is a host). Now that you understand what binary is, let’s have a look at our two subnet masks from the beginning of my post: If you were able to convert these numbers to decimal then congratulations! You’re ready to move on to the next section. Here is a list of binary numbers, try converting them to decimal and check your answers at the end of this post. Let’s look at the decimal number Let’s look at the decimal number 103 in binary format: We say the number places are grouped by 2’s because multiplying each number place by 2 gives you the next number place. The binary system has a 1‘s place, a 2‘s place, a 4‘s place, an 8‘s place, a 16‘s place and so on. Let’s look at the decimal number 103 by place.īy now you probably feel like you have attended Kindergarten for the second time in your life? Sorry about that but it is very important that you understand the concept of what a number system is, and what it is based on before we look at binary.īinary is a base 2 system, and thus groups numbers by 2’s and not by 10’s like the decimal system. We say the number places are grouped by 10’s because multiplying each number place by 10 gives you the next number place. ![]() The decimal system has a 1‘s place, a 10‘s place, a 100‘s place, a 1000‘s place and so on. We name the ten digits: zero, one, two, three, four, five, six, seven, eight and nine. It is believed that the system evolved because we have ten fingers and ten toes which over the years we have used for counting. What makes the decimal system a base 10 system is that it is based on grouping numbers by 10’s. The first thing you must know is that the common number system used world wide is the decimal system (otherwise known as base 10). Quick Subnetting How-To (Thanks to GeekVenue.) ![]() Number of Hosts – Refers to the number of effective hosts, excluding the network and broadcast address.Number of Subnets – “( )” Refers to the number of effective subnets, since the use of subnet numbers of all 0s or all 1s is highly frowned upon and RFC non-compliant.127.0.0.0 is reserved for loopback and IPC on the local host.Reserved address ranges for private (non-routed) use (see RFC 1918): At the bottom there is a quick how-to on calculating subnets.įor more information on subnetting, see RFC 1817 and RFC 1812. You can use this to quickly look up how your might need to subnet your network. Ths is an Internet Protocol (IPv4) Subnet Chart. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |